Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Holly

Posts

Holly

#1

Holly

richinva

>Have a small amount of holly, fresh cut, bark on. This will become, mostly, stoppers, pulls, etc., since it�s only about 2 �� at the largest section. Wondering the best way to dry it: Cut it into blanks a bit longer than what I�ll work, leave it long (longest piece is about 5�), or what? Any other tips for drying? Times?

Many thanks.

Rich

Re: Holly

#2

Re: Holly

richinva

>not 5" long, should be 5' long............good one rich..............

Re: Holly

#3

Re: Holly

John Lucas

>If your going to use if for small stuff split it at the heart, seal the ends and put it up to dry. For christmas ornaments and bottle stoppers I cut the wood into square pieces about 12 to 15 inches. These fit on my shelves.

I divide the log in to squares starting as big as 3x3 and then cut the remaining odd shaped pieces into whatever I can as small as 1x1. I occasionally lose an inch or so off the ends but I've had excellent luck doing this. I start the drying with the blanks on the concrete floor with a spacer between them and the floor. After about 6 months or whenever think about it I move them up to the shelves.

Re: Holly

#4

Agree with John

Bert Smith

>If at all possible get the holly cut up and sealed. My experience with holly left to dry as a whole log causes staining of the wood.

Bert

Re: Holly

#5

Re: Agree with John

Tom Sontag - St. Louis

>Holly does stain very easily, even after cut into lumber. I would try to have some air flow to prevent blue stain.

Re: Holly

#6

Thanks!!!

richinva

>Thanks guys, I'll cut it to length and square it up this evening and let it dry in the shop.

Much obliged.

Rich in VA