Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

needle decaler

Posts

needle decaler

#1

needle decaler

George Tyler,Louisa, VA

>I can't find the last thread on the use of a needle decaler for texturing. I remember putting a tight rubberband around the needles and maybe sharpening each of the needles to a point.

Has anyone had any experience using one ??

Thanks,

George

Re: needle decaler

#2

Re: needle decaler

James McClure

>There was an article in American Woodturner by Bob Rosand a while back about it. You are on the right track, but I think you just round over the ends instead of making sharp points.

Re: needle decaler

#3

Needle Scaler

Jennifer@Indy.USA

>George, it's needle scaler not decaler...try another search.

: )

Jennifer

Re: needle decaler

#4

Re: Needle Scaler

George Tyler,Louisa, VA

>Thanks ! I will try to find the article and do a search with the proper name. I'm a welder and just happen to have this device. Yesterday, I used it with marginal success.

George

Re: needle decaler

#5

Re: needle decaler

Gerry in Maryland

>Hi George,

I've been using this tool a bit lately. I disassembled it and sharpened the "pins" and reassembled the tool. I didn't care for the effect at first but then I just dulled the pins a bit by "descaling" my garage floor (concrete) until I got the effect I wanted.

Hope this helps.

Gerry


img

Re: needle decaler

#6

Re: needle decaler

George Tyler,Louisa, VA

>Thanks, Gerry. That seems to be the texture I would like to create on some of my turnings. I'll try the needle modification.

George