Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Lathe Upgrade

Posts

Lathe Upgrade

#1

Lathe Upgrade

Tony

>Have the 12 inch Jet. It was a good lathe for 3 years and is probably still a good lathe. But it's limiting me now, and It's showing some age, it could use a good going over. Beginning to think of a slight upgrade, wondered what. At this point, a 220 connection isn't an option.

Used is fine, but point me to places to look and ways to evaluate.

I turn bowls almost exclusively, and would like to stay right around a grand to 1500 for now.

Or might I be better served to just wait and get a nice Oneway or Poolewood or something in another year?

Another post suggested the Nova 3000 used, I think that would be a good deal, I really wanted it when I got my Jet but couldn't afford the extra cash at the time, but used now...not so bad, and it won't lose much more value.

Thanks.

Re: Lathe Upgrade

#2

Is 240v really out of reach?

Jay in TX

>When I was planning an upgrade, I thought of that challenge as well. Is it really a problem... not for most. You too can have a 240v power source with little effort and expense.

Option 1 (my solution) requires that you get the appropriate hardware, a wiring made simple book from the library (you may have to actually read it), and about 15 minutes to make an extension cord. This of course only works if you have a 240v connection/outlet near your working area. Our garage happens to be connected to the house via the laundry room, so I had the dryer hook-up to work from and voila I can now accommodate 220v machines! This solution works for me, but is mildly inconvenient at times.

Option 2. Have an electrician put in an outlet... the closer to the panel/sub-panel will probably be cheaper (time).

If I didn't move around all the time, I would've gone with option 2. It would be so nice to have a dedicated outlet! I just can't even imagine the elation these guys with mulitiple outlets on every wall! Hi, I'm jay, I have shop envy...

Re: Lathe Upgrade

#3

Re: Lathe Upgrade

Sean Troy

>The Jet 1642 1 1/2 hp 110v may be a great option. 16" swing. It does need a 20 amp breaker.

Re: Lathe Upgrade

#4

Re: Is 240v really out of reach?

Tony

>well...yes and no. The best way I can think of doing it is running a new line in to a new panel, one just for the shop. And that may not be a terrible thing, just that right now I can't do that and upgrade the lathe.

So maybe I should just make my plans to upgrade shop electrics and shop around for another year or so.

I'd still like to know some good used late sources though. Besides the classifieds here, I mean.