Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

buffing attachment for lathe

Posts

buffing attachment for lathe

#1

buffing attachment for lathe

ben d.

>Pic's of the buffing attachment that I made to use on my lathe. From end to end it is 33 in. The wheels are 8" the first 2 are cotton and are singles and the flannel wheel is doubled.

3/4 in shaft with morse taper on one end and a center hole on the other to use with a pointed live center. Flat washers and spacers to space the wheels. The spacers are not a perfect fit to the shaft and wobble a little but causes no problem.


img

Re: buffing attachment for lathe

#2

Re: buffing attachment for lathe

Curt Fuller

>Nice buffing setup. What did you use to buff that lathe up so clean?

Re: buffing attachment for lathe

#3

JL

Re: buffing attachment for lathe

JL

>He has to have been turning on it. Look at the shavings and "spatter" on the back wall :).

Re: buffing attachment for lathe

#4

Quick question

Garrett in Victoria

>What prevents the washers/wheels from sliding sideways?

Cheers, Garrett

Re: buffing attachment for lathe

#5

Re: Quick question

ben d.

>Havent had this lathe but about 8 months and just don't have it cruded up yet.Kindly been particular I guess.

#2 morse taper on the drive end then a locking collar secured by set screws then the spacers washers wheels to the other end where it is threaded and double nut-ed to keep everything in place. The center hole on the nut end is large and deep enough so the pointed live center keeps everything in place.