Out the door I go for the exchange
chris rolke
>I am shipping this out today
12.5" in diameter ( turned on a jet 1236)
maple and walnut
Knowledge You Can Build On — Est. 1998
Out the door I go for the exchange
chris rolke
>I am shipping this out today
12.5" in diameter ( turned on a jet 1236)
maple and walnut
Very Nice work!
T Daniel
>
Re: Out the door I go for the exchange
GaryG in MD
>Chris, Given the 12" limit of the 1236 on the ways, you must have turned that plate outboard. What did you use for a tool rest holder? The tool rest extender that came with my Jet 1236, nominally for outboard turning, broke in half the first time I used it, and I was warned not to replace it. Consequently, I've never done any ouotboard turning. Do you use a floor mounted tool rest? ...Gary
Re: Out the door I go for the exchange
chris rolke
>i did turn this outboard
i did use the adapter thing that came with the lathe
on this particualr pice i didnt even support it from the bottom like i have in the past
( with that i used a piece of 4x4 and made it fit under to help stop the excessive bouncing )
this one was done with very light cuts using sharp tools
i am still wanting to make an outboard turning rest but just havent done it yet
Re: Out the door I go for the exchange
Dick Hines
>Someone is going to be very happy.
Re: Out the door I go for the exchange
Dennis Y
>Very nice Chris. Anyone would be tickled to receive it. Dennis
Re: Out the door I go for the exchange
Pat Mulligan
>Nice. Lotta work went into that.Another lucky person on the other end.