Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

HF34706 Reeves/Belt Question

Posts

HF34706 Reeves/Belt Question

#1

HF34706 Reeves/Belt Question

George (Oxford, NC)

>There has been discussions on various forums about how the belt gets torn up on the HF34706. I just purchased a used one and while familiarizing myself with it, I studied the reeves pulleys. The inside of the four flanges have alternate indented and raised lands. The transistions between the two lands are very sharp corners. The transistions on the outside of the flanges are rounded over and very smooth. It seems to me that the very sharp edges on the inside of the flanges serve to cut up the edge of the belt badly thus eventually (short eventually) tearing the belt up. Has anyone tried (or thought about) taking a small file and rounding over the sharp edges? Or, are the edges there on purpose to help grab and drive the belt? Would the belt be more likely to slip if the sharp edges were not there? I want to try it but I don't want to have to buy four new flanges after I do it and find that there is a reason that they are sharp.

Second question, does anyone know an easy way to change the belt on this machine. It appears that you just have to muscle it off and on.

George

Re: HF34706 Reeves/Belt Question

#2

Re: HF34706 Reeves/Belt Question

GeeSeaWhy

>This link http://www.newwoodworker.com/bltrplcjwl1236.html is an article by Tom Hintz about changing the belt on his Jet 1236 which looks to be identical to the HF34706, at least as far as the drive system goes.

I never tried filing the pulleys as you suggest but I suspect it wouldn't have much effect because the belt is held further out, between the pulleys. I eventually put a link belt on instead. If the belt looks worn, don't just order one replacement. Order two or three - sometimes HF is not real speedy with replacement parts.

Graeme

Re: HF34706 Reeves/Belt Question

#3

Re: HF34706 Reeves/Belt Question *LINK*

Jeff Rich

>I go through belts on my lathe like no other.....

The only way I have found to change the belt is to separate the pulley on the motor, then slide the belt over the headstock pulley.

I usually order 5 to 10 belts at a time now....as they are les than $2 each, I have 2 of these lathes and they have served me well.


Jeffs Goblets