Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Hollow form thickness question

Posts

Hollow form thickness question

#1

Hollow form thickness question

Vicmarc.fan

>I have 6 things of sycamore about 8" around at the largest and about 12" high that I rough turned to about 3/4" thickness. They were placed in ahcohol overnight and left to dry till they lost no more weight by my scale. I have tried to finish turn the outside of two of the pieces and made the outside thickness the same as the inside on both trying to get them round again. My question is do you need to change the 10% rule on hollow forms or does sycamore distort a lot while drying? Even better question is what to do with the other four now?

Ron

Re: Hollow form thickness question

#2

Re: Hollow form thickness question

JamieDonaldson

>Trying to twice turn vessels is a risky business- the distortion during the drying period often causes fatal problems. Hollowing to a uniform thinness the first go-round is a better and more productive method.

Re: Hollow form thickness question

#3

Re: Hollow form thickness question

Vicmarc.fan

>I turn what I can find which usually comes from a forestry dump. I have never turned a green hollow form that didn't split or distort so badly I didn't want to put my name on it. That is why I tried the alchol thing.

Ron

Re: Hollow form thickness question

#4

Re: Hollow form thickness question

Norm Smith in Nova Scotia

>Hi Ron,

I rough turn a lot of hollow forms to the 10% rule and put them in alcohol, etc. I have not lost one so far. I used to coat them with end sealer with great success also. I find the alcohol is much faster. I have never turned sycamore so cannot advise on same.

Norm

Re: Hollow form thickness question

#5

Re: I've got sycamore in my lathe right now.

Al Crandall (NE of Indy)

>It is 14" d. by 6" to 7" deep, with bark on and a slightly closed form. It was roughed to a heavy 1 1/4" thickness and cleaned up at about 1/2". I've found sycamore to move a lot. This piece was roughed before I started using Dave's alcohol, but it has dried for over 20 months. Two different growth rings gave me fits with tearout, while the rest of the piece cut without incident. No drying cracks anywhere.

Re: Hollow form thickness question

#6

Re: Hollow form thickness question

Anthony Y

>I'm with Jamie on this one, I've turned over 900 green hollow vessels with very few problems with cracking. Finished thickness is about 1/4". Of course I've made some TOO thin if you know what I mean lol.

Re: Hollow form thickness question

#7

Re: Hollow form thickness question

Barry Irby

>Why don't you wet them enough to make them round again and finish turn them and let them dry?