Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

CA repaiirs and finishes????

Posts

CA repaiirs and finishes????

#1

CA repaiirs and finishes????

Carole in VA

>I am almost finished with a maple hollow form. It has a very small bead at the opening, but I just noticed that there is a tiny crack starting on the opening side of that bead. I want to stop it with CA but I also want to use lacquer as the finish. Will the CA interfere with the lacquer? The darn thing is finish sanded up to 600 so I can't take off much more without destroying the detail of the bead and I really like that silly little bead. :( Oh, and what is it that doesn't stick to CA...was it polyester batting? Help! Gonna wait 20 minutes or so and see if anyone is around. If not, I guess I will just say a prayer and wing it! LOL

Re: CA repaiirs and finishes????

#2

Re: CA repaiirs and finishes????

georgetroy

>Hi Carole,

I use the Deft Clear wood lacquer first, then apply your super glue. The lacquer keeps the CA from staining or whitening. If the CA is first then more than likely it will soak in and cause a color change.

Re: CA repaiirs and finishes????

#3

Thanks George, but

Carole in VA

>it's too late for this one. :( I started to do that but I figured the CA would not get past the lacquer to get down in the crack. I used about half a drop of the CA on the inside of the neck and the darn stuff wicked right on thru the wood to the outside. I knew better than that...I was afraid it would do that, but I just got impatient and wanted to get the thing off the lathe before I went in for the night. :(

Oh well, another practice piece. It was pretty ugly maple anyway. LOL

Re: CA repaiirs and finishes????

#4

Re: CA repaiirs and finishes????

Jim Pugh, Ohio

>One of the things I have some success with is to sand the crack area with 220 or 320 paper to get some fine dust in it. Then carefully apply the CA to the crack (but have a cloth ready just in case... DAMHIK), then immediately after applying the glue sand the area again. If you are real lucky and hold your mouth right you can get the crack glued and not have a stain.

Re: CA repaiirs and finishes????

#5

Re: CA repaiirs and finishes????

Ed

>Howdy Carol: I have to agree with georgetroy. I use super-thin CA that I get from Starbond because it's the thinnest I've found. I use spray Deft. Spray across the crack, not town into it. That will keep the crack from filling up with lacquer. Put on as many coats as necessary, depending on the wood grain - usually 2 or 3 will do. Then put the CA down into the crack. It will wick down quickly. Wipe excess off with a paper towel. You're good to go! I have very good, but not perfect success with this method. Coarser grained woods are really tough to do. The lacquer works because it's a surface finish and will sand off easily when you're done.