Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Inlace hardener

Posts

Inlace hardener

#1

Inlace hardener

Mike Cunningham (Cape May)

>Having never used inlace I have some questions. Is the hardener the same as that used in two part epoxy resin? If not, can epoxy resin hardener still be substituted? What about polyester resin hardener?

Also, has anyone ever mixed metal filings, such as those from key cutting, with epoxy resin to be used as a filler or is some other substance preferable?

Thanks.

Re: Inlace hardener

#2

Re: Inlace hardener

John Lucas

>Inlace is a polyester resin, it's like liquid Corian counter top material. I won't say epoxy resin won't work because I 've never tried it but the base material is different than epoxy resin. I wouldn't try it. The hardeners not that expensive.

You can mix must about anything with it if you keep the percentage of volume low. I know epoxy manufacturers say more than 10% by volume will lessen the strenght of epoxy or affect the curing time. I've mixed metal of all sorts with inlace and not had a problem. I don't know what actual percentage by volume I've used but probably not more than 20% and usually way down. It still hardens. I would not trust it for structural strength at these dilutions if you want to call it that.

Re: Inlace hardener

#3

Re: Inlace hardener

Ron in Drums PA

>John is right

Cast-n-craft works as well as Inlace and is less expensive. The hardener is interchangable.

Re: Inlace hardener

#4

Re: Inlace hardener

Mike Cunningham (Cape May)

>I thought that inlace was a powder-like material, apparently it's a liquid polyester. So, what about ground powders and stone, can they be mixed with two part eposy and used as a filler?

Re: Inlace hardener

#5

Re: Inlace hardener

Darryl Hansen

>Mike, Inlace is sold as a powder and nuggets as well as in a resin. You can buy clear resin and mix the nuggets or powder in the clear. You can also buy a "kit" that has the powder and nuggets in the resin. Check with turtlefeathers.com and call them they will help answer any questions you have about Inlace. The web site also explains quite a bit about the various materials and kits.

Re: Inlace hardener

#6

Thanks all!

Mike Cunningham (Cape May)

>

Re: Inlace hardener

#7

Re: Inlace hardener

Barbara Gill, Remlik VA

>I tried the liquid two part Inlace resin several times and always had trouble with it not getting hard. I am sure it was my fault even though I measured. I tossed the liquid and now use West System epoxy for large voids. I use coffee grounds, metal filings, black coloring paste all with no problems what-so-ever.

Re: Inlace hardener

#8

Re: Inlace hardener

Mike Cunningham (Cape May)

>Thanks Barbara! One reason for my question, I have about 2 gallons of epoxy and hardener left over from a boat restoration. I'd like to use it with the materials that we've mentioned rather than buy something else and see this stuff wasted. Thanks!