3 point tool
kenny in indep
>Hello, At a recent tool auction in Kansas, I bought a 3 point tool. How is this tool used? Thanks for your time, Kenny in Indep.
Knowledge You Can Build On — Est. 1998
3 point tool
kenny in indep
>Hello, At a recent tool auction in Kansas, I bought a 3 point tool. How is this tool used? Thanks for your time, Kenny in Indep.
Re: 3 point tool
John Lucas
>There is a good article in the fall issue of American Woodturner if you can get hold of one of those. They did have a video on the website but I looked and couldn't find it.
Re: 3 point tool *LINK*
Fred in NC
>Wow... much as I have tried, I can still only find ONE point in that tool. I did find 3 sides, tho... Link below
Video
Super link and video
Ed Moore
>For those with a high speed connection, this is a super video. It is actually on the AAW site under "Resources". I found it to be very clear and understandable. For those who have no experience with the three-sided round tool, this should be enlightening. I recommend it.
Ed in SW VA
Re: Super link and video
JKJ in East TN
>>For those with a high speed connection, this is a super video.
For those without a high enough speed connection to play it smoothly, you can right click on the link in the message and use "Save Target As" in IE to save it to your disk (about 21 megs). It should play find then and you can play it offline.
JKJ
Re: 3 point tool
kenny in indep
>Hello, looked again, I can't find those other two points, must be one of them Missouri things. Thanks for the response, I do like this site, have learned a lot just reading posts.
After close to 3 hours
Bob Hackett(Mainely,Bob)
>of download time all I can get is sound played thru Winamp.Was hoping it was something I could use in class.
MB-Who`s 56K dial-up only works at 24K max due to Maine rural phone lines.Big disappointment.
Re: After close to 3 hours
Fred in NC
>Mine plays OK in Windows Media Player, you might need to upgrade to the latest version. I hope you saved the file after than long of a download.