Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

Alaskan Mill Question

Posts

Alaskan Mill Question

#1

Alaskan Mill Question

Raymond Overman in SC

>Has anyone used a Granberg Alaskan mill for slabbing small diameter (<18") trees? Specifically the G777 model? Any opinions or thoughts on it?

Re: Alaskan Mill Question

#2

Re: Alaskan Mill Question

Mike Sloan

>Hi Raymond,

I have used the Granville Alaska Mill to slab a couple of cherry trees. I think my Mill is a 30 inch mill. Even though my saw has only an 20 inch bar, (3.5(?)HP Stihl 290 Farm Boss, which is seriously under powered for the job), I would not get a Mill less than 30 inches, just for the future flexibility.

The mill works quite well, but it is a ton of work, and eats up a lot of wood. If I had a bigger saw, I would be much happier.

Mike

Re: Alaskan Mill Question

#3

Re: Alaskan Mill Question

Jerry Whitaker

>Check this site out......I think the Logosol Timberjig is far superior to the Alaskan Sawmill

logosol.com/webb/sawmills/2002a-timberjig.php?p=5