Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

Buffing Watco question.

Posts

Buffing Watco question.

#1

Buffing Watco question.

Barry Irby

>Could someone that buffs Watco Danish oil 'plain the procedure to me? I have the Bealle buffing system and understand the three steps. What I want to know is how many coats of Watco and how long do you wait before you buff. Also, for a food safe bowl, do use the carnuba?

I'm working on a walnut tray or platter.

Re: Buffing Watco question.

#2

Re: Buffing Watco question.

Mike Schwing from Md.

>I love it when someone asks specific questions! Here's a few specific answers.

1. How many coats of Watco?

I usually apply 3. Sometimes 2. Depends on how the particular piece allows for penetration, and the look and feel I'm after.

2. How long do you wait before you buff?

I've tried lots of different time schedules. 2 weeks after the last coat always works well for me. Sometimes sooner works fine, too, but 2 weeks ensures the finish has hardened, at least given the environmental conditions in my basement shop.

3. For a food safe bowl, do you use the carnauba?

You may, carnauba wax is generally considered food safe. The pleasant results you get with it will be short lived though, as getting the finish wet will cause it to dull rapidly/immediately. Because of this, I no longer use the watco/buffing procedure on food bowls. My customers get upset when the glossy finish disappears. I now use only Mylands or Briwax.

Re: Buffing Watco question.

#3

Re: Buffing Watco question.

Niedling

>Barry,

Generally 2 - 3 coats depending upon the wood. For wood like Cedar, it may take 5 -6 coats.

I have never been in a rush to finish my work or maybe it is because my day job interfers with getting the time except for weekends. You do want to make sure it is hard and dry. I would wait a couple of weeks here in Tennessee, perhaps less where it is warmer & drier.

I would not use the beal system on something that was going to be used for food. Also Watco oil would not be the best choice either. Their are plenty of food safe finishes that can be purchased such as walnut oil.

Re: Buffing Watco question.

#4

Re: Buffing Watco question. *LINK*

JKJ in East TN

>Barry,

I usually apply Watco every day for a week or so, then let it dry a couple of weeks before buffing.

People worry a lot about "food safe" but most experts say nearly any finish is food-safe if it's properly dried. That is, unless you eat the platter (and a few dozen more like it). I suspect the natural extractives in walnut are worse than any finish and not even very nutritious. But dead powder post beetle larvae might supply some protein.

All that I've read indicates carnauba wax is "generally recognized as safe" to eat and approved by the FDA. It's commonly used as a coating for candy and an ingredient in other foods.

JKJ


eating carnauba wax

Re: Buffing Watco question.

#5

Carnuba wax

Jack Savona

>I was in some store...somewhere...today following SWMBO/LOML around doing holiday shopping and picked up a FOOD item whose first ingredient was listed as "carnuba wax". Can't remember the item; the day was all a blur.

So I guess if I'm buffing...and hungry....

Re: Buffing Watco question.

#6

Re: Buffing Watco question.

Barry Irby

>Mike, Can you tell me a little about the Mylands and Briwax? I doubt they are available at Lowes and would have to go to Woodcraft. It seems I can either work or I can drive to Woodcraft. Sometimes it's a wonder I get anything done.