Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Another question about Steel

Posts

Another question about Steel

#1

Another question about Steel

DWR

>... as a follow up to the previous thread from Carole about HSS for tool tips, I want to make a few bent or goose neck tools and was wondering what grade of steel would be best for the bent handles.

Since it needs to be bent, ground, drilled and tapped, but does not have to hold any edge, I would suppose that any mild steel that is not hardened or tempered will work. Yes/No?

Ignorance is bliss in the NW

Re: Another question about Steel

#2

Re: Yes

RussFairfield

>

Re: Another question about Steel

#3

Re: Another question about Steel

John Lucas

>I just use the steel bars you can get from lows for all my boring bar tool shafts and anything that doesn't hold an edge. The exception is tool posts. Drill rod comes in very precise sizes and works better for tool rest posts. The downside is that it is very hard to cut by hand. It will take an hour of some really good aerobics to hacksaw through a 1 inch bar. I used to use an angle grinder with a cutoff disc. This was slow and would grab on you if you aren't careful. This last summer I bought and antique powered hacksaw for $50. Took very little time to recondition and boy does it work great.

Re: Another question about Steel

#4

Don Pencil

Re: Another question about Steel

Don Pencil

>1018 steel is kind of the norm. 12L14 also works.

Handles and forearm supports on the Scorpions are made from 12L14. It is not quite as strong a 1018 but is much more machinable.

The tools are made from 1018 as it is stronger. I prefer it for use in a long shaft.

All the cutting bits are made from HSS.

In the end it will depend on the use of the tool. If the tool will be subject to pressure and stress, 1018. For applications of less pressure and stress, 12L14 will do. It costs just a little bit more but it is much easier to work with.

I hope this was helpful to all and answers your question.

Be Well,

Don Pencil

WWW.DONPENCIL.COM

don@donpencil.com

Re: Another question about Steel

#5

Re: Another question about Steel

Bill Crommett

>I have always used Cold Rolled for my shafts and handles. What is its numerical designation ?

Re: Another question about Steel

#6

Don Pencil

Re: Another question about Steel

Don Pencil

>1018 and 12L14

Re: Another question about Steel

#7

Thanks...

DWR

>.... everyone.

I feel like I have enough information to be dangerous, so that must mean it's time to act!! Look out world here I come...

Dave

Re: Another question about Steel

#8

Re: Thanks...

Lan Brady

>After reading all the post, I ordered 8 inch bits from MSCdirect. The tools were delivered within 19 hours of placing the order. Shipped from Pennsylvania to North Carolina.

Thanks from me too for all the guidance.

Lan