Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Spindle spacer for Powermatic 3520

Posts

Spindle spacer for Powermatic 3520

#1

Spindle spacer for Powermatic 3520

Craig Daymon

>Refresh, I found a great deal on some 6" faceplates that were threaded right for my PM 3520. Then, I posted the info here and was told in follow-up messages that the spindle on the PM is longer than most and that for the faceplates to seat correctly I would need a spindle spacer.

Powermatic had some trouble initially, but finally found the part. The problem was, what was sent out (and please, those that have one, let me know if this does not sound correct ) was a spacer for their shaper. It is NOT a THREADED part, but simply slides on and, according to PM, is the perfect size.

Thanks for the help,

Craig

Re: Spindle spacer for Powermatic 3520

#2

Re: Spindle spacer for Powermatic 3520

John Lucas

>Craig I was afraid that the Nova faceplates would be shorter than the Powermatic. The spacers they send you are nylon and I had to have 2 to make some of my old faceplates seat. They are just like nylon washers with no threads. They work great.

Re: Spindle spacer for Powermatic 3520

#3

Re: Spindle spacer for Powermatic 3520

John Lucas

>I forgot to say that I don't know how much if anything you had to pay Powermatic but you can buy the same thing from Craft Supplies if that helps you any.

Re: Spindle spacer for Powermatic 3520

#4

Powermatic was very obliging (sp?)

Craig Daymon

>Actually, Powermatic was very helpful. They are sending me the spacer for the shaper and a few of the nylon lock prevention washers as well. (Should have asked for a few of the washers for my JET mini too! Darn!)

No Charge. Of course, the lathe is new (old model, new purchase) and I think that is why it is coming no charge.

-Craig

Re: Spindle spacer for Powermatic 3520

#5

Re: Spindle spacer for Powermatic 3520

George Fitzpatrick - Springfield MA

>When I got my Delta midi lathe, I found out the hard way that they did not include the spacer. Mounted a piece on the faceplate, put it on the spindle and the spindle knocked off the piece, as the spindle was longer than the faceplate. I took a piece of 3/4 inch plywood and made a washer out of it. Used a forstner bit for the center hole, and it works like it was made for it.

geofitz13@msn.com

maker of fine sawdust

Re: Spindle spacer for Powermatic 3520

#6

Re: Spindle spacer for Powermatic 3520

Tony Reynolds somewhere near Newark, OH

>The spacer they sent me was steel and approx 1/2 to 5/8" thick ( it's out in the shop would have to go measure it) and just slid on the shaft. Worked perfectly. No charge, but lathe was fairly new at the time.

Tony

Re: Spindle spacer for Powermatic 3520

#7

MDF works very well

Bill Howatt

>