Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

bowl gouge sharpening

Posts

bowl gouge sharpening

#1

bowl gouge sharpening

Patrick Capobianco

>I just purchased a 1/2" bowl gouge and wondering if I should hone it at the same degree and profile or should I change it I also have a 3/8" bowl and using a Tormek grinder any suggestions will be appreciated.

Re: bowl gouge sharpening

#2

Re: bowl gouge sharpening

Walt Drummond, Middlesex, NJ

>Patrick, I'd redo it to a 65 degree angle with swept back sides. The Tormak has an attachment for bowl gouges that does a good job. Might need to shape it with a rougher wheel to start.

Walt

Re: bowl gouge sharpening

#3

Re: bowl gouge sharpening

Russell L. Babbitt Jr.

>Anywhere between 55-65 is the "norm". If you have been using your other gouge you know wether or not it works for you. Check out the sharpening tips here at WC to see the difference between factory and sweptback grinds. If you try a new grind and it does not work for your needs you can always regrind it. I have almost two each of my bowl gouges. One has a straight across grind the other has a fingernail grind. If I had one choice I would use the Ellsworth grind. If you can check out his DVD on using his gouge. The information included in this DVD can be applied to other bowl gouges not just his.........