Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Target Coatings WB Finishes

Posts

Target Coatings WB Finishes

#1

Target Coatings WB Finishes

David Hammond, in Powder Springs GA

>I've been doing some reading about these finishes and I was wonderful if anyone here could give me some practical, hands on experience with this stuff - did you like it? Is the USL as good as they say it is for rubbing out? Is the USL and the 9000 poly "good enough" to replace the traditional solvent/oil based laquers and poly's?

Tia.

David

Re: Target Coatings WB Finishes

#2

Absoloootly!

Mark Mandell - Gone Round In Jersey

>I use both products for furniture work. My applications are with a Walcom Geo HVLP conversion gun, and the Ultima flows out beautifully. I use the 9000 for table tops. I use both products over a dewaxed shellac sealing coat. Pic is of a cherry & walnut coffee table done in Ultima over Watco sealed with dewaxed garnet shellac.

I also use Fuhr 355 which is a great self-sealing waterborn acrylic varnish that gives a very hard and durable coating in applications such as kitchen and bath cabinets. Comes off the gun so smooth that I haven't bothered to rub it out at all.


img

Re: Target Coatings WB Finishes

#3

PS

Mark Mandell - Gone Round In Jersey

>I'm still not sold on waterbornes for wood floors. For my $ there's still no match for thick-film oil-based poly for walking on in the hard-film finishes, and long oil Gym-Seal for a softer scratch-free finish.

BTW If you're hand-applying the Target to turnings, using the SA-5 additive and the foam brushes will make a big difference.

M

Re: Target Coatings WB Finishes

#4

Re: PS

David Hammond, in Powder Springs GA

>Thanks Mark! Your info was exactly what I needed to hear. I've got some of the USL and the 9000 in the mail right now to experiment with. Jeff from the Target Coatings wesite also answered some questions for me, and between the two of you I'm now very excited about trying these finishes!

Thanks again,

David