Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Domestic, Figured & Live Edge Hardwoods in Stock. Best Prices for Serious Woodworkers.

A tip for using machinist's live center on wood.

Posts

A tip for using machinist's live center on wood.

#1

A tip for using machinist's live center on wood.

Al Crandall- NE of Indy

>Keith and Jennifer's recent discourse on inexpensive live centers prompts me to offer this tidbit to anyone who might be contemplating purchasing one of these tailstock held wood splitters. It is tough to apply a lot of pressure with a center of this design because it just buries itself deeper into the wood with additional pressure until the failure point of the wood is reached. The solution is to slip a small steel flat washer on the 60deg. point before engaging the wood. Pick a washer diameter which exposes the amount of point which makes you happy.

Re: A tip for using machinist's live center on wood.

#2

Re: A tip for using machinist's live center on woo

Curt Fuller

>That's a fantastic idea! Thank you very much.

Re: A tip for using machinist's live center on wood.

#3

Re: A tip for using machinist's live center on woo

Scott Greaves

>That's a good one Al! Thanks!

Scott.

Re: A tip for using machinist's live center on wood.

#4

A slight refinement

Barry Irby

>I did this and refined it by using a countersink on the washer. By running the countersink deeper and deeper, I could adjust how far the tip stuck through. I tried gluing the washer on the cone center with CA, but that did not hold.

Re: A tip for using machinist's live center on wood.

#5

Re: A tip for using machinist's live center on woo

George Van in WI

>Thanks Al, I will definately put your tip to good use.

Re: A tip for using machinist's live center on wood.

#6

Great Tip Al, Thank you

Jennifer@Indy.USA

>

Re: A tip for using machinist's live center on wood.

#7

Re: A tip for using machinist's live center on woo

Don Henthorn

>Now why didn't I think of that? Good show, Al.