Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

live centers

Posts

live centers

#1

live centers

Patrick Capobianco

>How important is a good live center, and which one would you recommend

if I were to replace? I'm still using the one the lathe came with, which is delta, very inexpensive.

Re: live centers

#2

Re: live centers

Denis Lalonde

>Check out the Oneway live centre...

Re: live centers

#3

Keith Tompkins

Re: live centers

Keith Tompkins

>Hi Patrick, depending on the type of work you do, the live center is critical. for fine spindle work, or work that has to be switched end to end, it's got to be free from wobble or play. for supporting a bowl, not too critical.

the Oneway is good but expensive, Jet has a knockoff but not much cheaper. Harbor Freight offers a surprisingly good one for twenty bucks...see my post below.

Re: live centers

#4

Re: live centers

John Lucas

>I have the Nova live center, along with the Powermatic copy of oneway and an old Delta. I like my Nova the best of them all. It's kind of in the medium price range. You can get them from Woodcraft I think.

Re: live centers

#5

Steven Antonucci

Just thinking about this yesterday...

steve antonucci

>because I got the Enco Christmas catalog. They had some live center systems (multiple insert points) that appeared to be pretty good value (~$50) plus free shipping for Christmas.

Anyone comment on the Enco centers?

Steve

Re: live centers

#6

Re: live centers

Craig Daymon

>I have an Axminster set. I haven't put it to use yet with the move and all, but their stuff usually gets good marks for being well made and the price was less than OneWay. The "faceplate" was a bit of a rip off as it was VERY small, especially for the price. I think I got it from Cutting Edge or Craft Supplies.

-Craig

Re: live centers

#7

Re: live centers

Fog Tanner

>That is the same one I got to replace my Oneway when the bearings got too sloppy for spindle work. The price was about $40 less than the Oneway when I got mine. I think all The Cutting Edge has now are 1 MT, so Craft Supplies is the only outlet now for 2MT.