Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Oneway Master Cut Handle

Posts

Oneway Master Cut Handle

#1

Oneway Master Cut Handle

Dennis Taylor

>I would like to find out if the Oneway Mastercut handle can be used with the P&N tooling?...I am not sure, if one is standard & the other metric, but there seems to be some debate between those I have asked...I like the Oneway handle, and like the prices of the P&N tools..can anyone shed some light?...Dennis Taylor

I have found that Woodturnerscataglog sells the handle, and Lee Valley sells the tools, any other sources....

Re: Oneway Master Cut Handle

#2

Re: Oneway Master Cut Handle

Mark Kauder. Phenix City, AL

>I have two Oneway Mastercut handles, and have a 1/2" P&N bowl gouge and a 5/8" P&N bowl gouge in them respectively. They fit just fine.

Mark

Re: Oneway Master Cut Handle

#3

Re: Oneway Master Cut Handle

Bill Neddow

>the Oneway handles are Imperial measure and the P&N are metric. The P&N tool shafts are just a litle small. Most people just crank down the holding screws and the combination works just fine. I did not like that, so cut a piece of tin, shaped it into a tube (with a slit so the screws could go through to the tool steel) and wrapped it around the tool shaft. Fits like a glove.

Re: Oneway Master Cut Handle

#4

Re: Oneway Master Cut Handle

Dennis Taylor

>Mark or Bill, I seen this number on the Oneway site, for the Sure Grip handle to accept this adapter to use it with other 3/8 diameter tools, do you happen to have this item and does it work

5/8" to 3/8" Adaptor

Part No. 2951

that I would like to order the Oneway handle, seems nice to use, used one during a turn & learn, and want to be able to use the P&N tools with it, but the 1/2 and 3/8 and looks like the Oneway handle accepts a 1/2 & 5/8 diameter tool and this adapter will allow the 5/8 end to accept a 3/8 tool, that should also work then with the P&N tool and Oneway handle.....Dennis