Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Sanding

Posts

Sanding

#1

Sanding

Sean Troy

>Hey all, I'm working on a maple platter and have it dry sanded to 600. What can I do from here to get the best look to pop the quilt? Thank's, Sean

Re: Sanding

#2

Re: Sanding

theeviltwinn

>Check with a magnifying glass for scratches. Sand to a higher grit if not satisfied. Wipe on a coat of boiled linseed oil. Let dry for a week. Finish as desired.

Re: Sanding

#3

Re: Sanding

georgetroy

>You can do a trial finish on some scrap wood. Do Deft clear wood finish and then an oil. How about Waterlox or Urethane oil first? With the trials you might fine the one you like best or close to what you are looking for. GT

Re: Sanding

#4

Re: Sanding

Sean Troy

>That may be a good way to go but I was also wondering if sanding further with higher grits may show off the grain even better. Thanks, Sean

Re: Sanding

#5

I agree - Boiled Linseed Oil. but..

Jim K in Trappe PA

>it will darken the wood a little. I have built a lot of furniture using tiger maple, and applying BLO has always been one of the most satisfying parts of the process. The grain really jumps out.

Re: Sanding

#6

Keith Tompkins

Re: Sanding

Keith Tompkins

>HI Sean, you can also dampen the surface, and allow to dry. This will raise any deep scratches to the surface, where they can be sanded with 600 grit or finer.