Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

I can't read...

Posts

I can't read...

#1

I can't read...

albertabob

>Ray Allens book edited by Dale Nish.It's called Woodturning with Ray Allen published by Fox chapel Publishing.

I'm trying to figure out the width of the feature ring as described on page 15 being 10.05" across and each segment being 2.012"

The the author goes on to show the ring with 16 more dividing strips of .125" in between the diamonds.

So what should the measurement be for each segment?

2.012 + 1.25?

I have been struggling with this book for weeks.

Somebody should proof read it before they reprint it agian .

It's really hard to read.

Bob

Re: I can't read...

#2

Re: I can't read...

Brian Hahn in SW Wisconsin

>I think your question is answered in the instructions on page 32. Step 58 calls for the diamond block to be 1.897 inches long. Subtracting that from the 2.012 segment length gives 0.115 for the walnut thickness, not the 0.125 printed in the text.

Hope that helps,

Brian

Re: I can't read...

#3

Re: I can't read...

albertabob

>Great stuff Brian!

I have read that passage several times but missed that gem.

This is one of the most poorly written and edited books on the market today for segmented turnings.

It's crammed full of typos and hidden references to discussions from several pages back in the text.

Had I not started this expensive project several weeks ago I would cheerfully toss it and the book in the garbage.

Once again, thanks for spotting that for me.

It could have been a disaster had I used the measurements suggested on the plan provided on pg 15.

Bob