Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Problem with Friction Polish

Posts

Problem with Friction Polish

#1

Problem with Friction Polish

Ronny Eelen

>Have been working on a small vase. It's sanded to 400 grid. Yesterday I put on a first coat of Chestnut Friction Polish, then rubbed it with a cloth while the lathe was running, slowly increasing pressure to get a shine.

Today I put on a second coat. But while holding the cloth to it and applying pressure these small ribbles have formed, all the way around (sort of). You can really see and feel them.

What am I doing wrong?

It is in an unheated shed in the garden, and it is cold here right now, about 2�C. The bottle of polish is also kept in the shed, and it does feel cold.

Any idea's, suggestions?

thanks

Ronny

Re: Problem with Friction Polish

#2

Re: Problem with Friction Polish

Gary Ratajczak

>In my experience, you heated enough to melt original layer. I use the French Polish technique on miniatures that I turn. I start with a small amount of polish on a cloth, and coat the object with the lathe off. With lathe on, and cloth positioned to catch off spray, I apply pressure starting at one end. Pause enough time to let some heat build, then slowly move to one end. Don't go back and forth. Once the polish is heated, and friction cured, you only re-melt and strip off if you go pack. When required, I lightly sand with high grit foam pads, then repeat. Again, one motion from end to end, not back and forth.

Re: Problem with Friction Polish

#3

Re: Problem with Friction Polish

Ronny Eelen

>I did a lot of back and forths... but I also did that on the first coat, and then it didn't seem to be a problem. Could be that I put on too much the second time.

Re: Problem with Friction Polish

#4

Re: Problem with Friction Polish

Scott Hurley in N. VA

>I've been having the same problem - little ridges (or gullys) in the final polish. I, too, have been going back and forth - I'll try your method. Thanks for the info.

Scott

Re: Problem with Friction Polish

#5

Re: Problem with Friction Polish

JKJ in East TN

>When I get ridges and irregularities I usually stop the lathe and rub on more friction polish by hand with the grain to smooth out the surface. The solvant in the polish will dissolve hardened polish. They turn on the lathe and apply polish again, but in very thin coats. I seem to have more trouble if I put it on thick.

JKJ