I turn my stoppers a little different.
Dave Smith, Longview, WA
>Hi Gary,
I turn my own dowels mostly out of big leaf maple because I have a lot of scraps from lumber. I am trying to get an article written about the process along with pictures. Basically I put a piece of 2" square, more or less, stock in my strong hold chuck. I usually start with about a 5" long piece. Taper the end down to a 1/2" tenon that is a little bit bigger than the 1/2" hole you will drill in the blank. Seat the blank on the tenon. If it is loose you can wet the hole with water to get a friction fit. Bring the tail stock up to hold the blank secure while you turn the shape and sand it. Part off the waste on the tail stock end and sand it smooth.
Since you are using a wood dowel to hold the stopper you can use a skew or spindle gouge to true up the end of the piece with out worrying about hitting any metal. When the tenon is too damaged to hold an other stopper turn a new tenon on the end and away you go. Also, mark #1 jaw on the turning square so you can remount it and not have to turn a new tenon. Fine grain, dense wood work best for the tenons. Pine, alder, red oak and walnut don't work very well. DAMHIKT
No special jigs or parts for you to buy.
Dave Smith
There are reasons why I don't make any money in Longview, WA.