Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Powermatic 3520 and 4224 owners

Posts

Powermatic 3520 and 4224 owners

#1

Powermatic 3520 and 4224 owners

Greg Jensen

>I need some help from Powermatic lathe owners. Recent I have had several inquiries about the tool post on McNaughton Center Savers being too short for the Powermatic lathes. I have demoed several times on both Powermatic lathes and had no problem using our 4" long column.

Could some owner please measure from the top of the Banjo, tool rest column, tightening screw to center on their lathes and report back to me?

Thanks for you help.

Greg Jensen

Re: Powermatic 3520 and 4224 owners

#2

Re: Powermatic 3520 and 4224 owners

John Lucas

>Mine measures about 5 and 5/8 or so. 6 inches to the bottom of the screw from the center of the spindle. My spindle measures about 10 1/4" from the bed but that was a rough measurement.

Re: Powermatic 3520 and 4224 owners

#3

Re: Powermatic 3520 and 4224 owners

George Van in WI

>Hi Greg,

On my 3520 it is 5 9/16� from the tightening screws centerline on the banjo to the spindle centerline.

When the gate is set for the coring tool to cut at centerline I have two inches of toolpost, with my 4� toolpost, (OAL 5 ��) in the banjo. The toolpost extends 1 inch below the tightening screws at this setting. Hope this is the information you wanted.

Re: Powermatic 3520 and 4224 owners

#4

Re: 4224 data

Al Crandall- NE of Indy

>"Could some owner please measure from the top of the Banjo, tool rest column, tightening screw to center on their lathes and report back to me? "

Glad to, Greg.

Centerline of spindle to top of tool rest column, 5 1/8".

C/L spindle to C/L of tightening screw, 6 1/8".

C/L spindle to top of banjo (clearance over banjo), 9 1/4".

OEM tool rest over all height, 7 13/16".

I have your center saver system. I had a new tool post machined from 2" diameter CRS. The large shoulder seating against the top of the banjo automatically sets my cutters on center.

Al Crandall