Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Lathe Tool storage and ballast box

Posts

Lathe Tool storage and ballast box

#1

Steven Antonucci

Lathe Tool storage and ballast box

steve antonucci

>To answer the "where and how" of tools storage, here is what I've come up with...

For starters, I have had a Nova 3000 for a few years and I bought the cast iron legs for it about 2-3 years ago. My guess is that the whole assembly is about 400# "naked". My original ballast box was on the lower section of the legs, but it created two issues. The first issue was that I couldn't clean up underneath the lathe at all. The second issue was one of physics. The lathe gets to most benefit from having the mass close to the headstock, so I decided to move the shelf to the location you currently see. About a year ago, I added a bottom to the box, and filled it with gravel (100#'s or so). The shelf also holds the battery to my rowboat, a 60# bag of water softener salt, driveway salt, and another headstock for my Nova. All totalled, another 200# on the shelf. Estimated weight of lathe= 700#.

Now I used to store my turning tools on the tablesaw top just to the rigt of the lathe, but I got tired of clearing it every time I needed to cut something, so I added the storage on the tailstock end. It is nothing more than a piece of 2x4, screwed into a piece of MDF with holes drilled in it for the tools. The whole thing is screwed into the ballast box. Tools are always at hand, and I have made sure that I store the longer tools toward the back, so that I can easily remove the tailstock (which typically ends up on the tablesaw...)

Additional notes: If you look at the leg on the right, you'll see a few super magnets. They are really handy for holding the chuck keys, allan wrenches, and such.

Steve

P.S. Wire closet shelving above the lathe has greatly reduced the amount of shavings above the lathe. 95% fall through.


img

Re: Lathe Tool storage and ballast box

#2

Re: Lathe Tool storage and ballast box

Barry Turner

>Uhhhh.....I'd be a little leary of storing all that salt near cast iron components. If that stuff spills, it will attact moisture and you will be needing a new lathe.......legs and all.

Re: Lathe Tool storage and ballast box

#3

Steven Antonucci

Needed to store it somewhere

steve antonucci

>Usually comes in heavyweight bags, and I tend to use the whole bag or nothing. The driveway salt on the right was an exception, and is ziptied shut. No issues.

I'm not advocating the use of salt for weight, since sand is cheaper and heavier for the volume. Pig iron even more so. Just happens to kill two birds with one stone in my garage... er, um, studio.

Steve

Re: Lathe Tool storage and ballast box

#4

A spare headstock?????

Stuart Johnson

>

Re: Lathe Tool storage and ballast box

#5

Steven Antonucci

Nova warranty policy is very good...

steve antonucci

>one phone call to Woodcraft, and I had it in a week from Tim Geist.

Steve