Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

need vacuum chuck for Jet 1642

Posts

need vacuum chuck for Jet 1642

#1

need vacuum chuck for Jet 1642

dick mc neill

>I know this thread was discussed recently but I can't find it on this site's search engine. I have just bought a Jet 1642. Is there a complete vacuum system that would fit that lathe with minimum set up (I'd rather turn then put together a home made vacuum chuck). I'm intrigued by the fact that the lathe's headstock handwheel is in fact a cylinder engineered for a vacuum chuck. Any & all advice is welcomed & appreciated.

Re: need vacuum chuck for Jet 1642

#2

Packard Woodworks, Oneway

Dominic Greco in Richboro PA

>Dick,

I have a Jet 1642 and have outfitted it with a shop built Vacuum Chuck system. I made rotary adapter in about 2 hours from components I purchased from Lowes. The Gast vacuum pump was purchased from Surplus Center .

However, if you're positive that you don't want to build your own (and I understand why you'd rather spend your time turning!), Packard Woodworks and Oneway both sell vacuum adapters that would work with your lathe.

You'll still need to buy or make a vacuum bell. There was a great article in a recent Woodturning Design Magazine on making vacuum chucks

Good luck,

Dominic

Re: need vacuum chuck for Jet 1642

#3

Re: need vacuum chuck for Jet 1642 *LINK*

DWR

>Here is something...


Vacuum Chuck