Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Finishing question

Posts

Finishing question

#1

Finishing question

George Fitzpatrick - Springfield MA

>Beginning turner here. When I am turning a bowl, typically, I find that I get tear out in what I think are the end grain points of the bowl, both inside and outside. I end up sanding...and sanding....and sanding.... Is this normal, or is my technique lacking? Right now I am working on a maple bowl, and it was quite noticable.

Once finished, I will try to post a pic.

Want to get a decent finishing technique down for the turning exchange.

geofitz13

maker of fine sawdust

Re: Finishing question

#2

Re: Finishing question

Niedling

>What you have described is end grain tear out. You did not mention what tool you are using. It should be a bowl gouge. The key is to keep it sharp. Especially for your last couple of finish cuts, re-sharpen your tool. These cuts should be light cuts. Some people will apply a some type of coating ( oil finish) before they make their last cut to eliminate the tear-out. Make your finish cuts a few minutes after applying the coating. There are other advanced techniques like shear scraping that would help.

Main key is good technique, keep the bevel rubbing, a sharp tool and practice.

Re: Finishing question

#3

and....

TD

>try to learn to keep the cutting edge at 45 degrees to the work. This will result in a slicing cut which will almost eliminate tear. When making a slicing cut your curls will look like corkscrews. When finish cutting a bowl you should be standing in corkscrews.

TD

Re: Finishing question

#4

Re: and.... *LINK*

joaz

>Maple can be a bitch...try applying shellac, let it dry....sand.


http://www.maine-web.com/woodturning

Re: Finishing question

#5

Re: Finishing question

George Fitzpatrick - Springfield MA

>I have been using a bowl gouge, trying to keep the bevel rubbing. As you said, practice...practice...practice. I do seem to be having trouble making consistent continuous fine cuts. But I am sure this will come in time.

Thanks for the tips, and Happy Thanksgiving!

geofitz13

maker of fine sawdust

Re: Finishing question

#6

Re: and....

George Fitzpatrick - Springfield MA

>Yeah, I agree that maple can be difficult. But it seems that it is about the only thing I can find around here besides pine. And I think that pine would be even more of a bitch...much softer, and I don't get the feeling that the figuring would be that interesting.

geofitz13

maker of fine sawdust

Re: Finishing question

#7

Re: Finishing question

Wally Dickerman in Arizona

>You can do everything right...rub the bevel on the gouge, etc., but if you cut against the grain you'll still get end-grain tearout. You're cutting against unsupported wood fibres. Try it..make a cut against the grain, then make a cut with the grain. You'll find a lot of difference. The same principle as planing a board against the grain. You'll get a torn surface. When turning end-grain, that's with the grain parallel to the lathe bed, cut from large dia. to small. When cutting face-grain, cut from small dia. to large.

Wally