Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

LED bulbs for gooseneck mag base lathe lighting

Posts

LED bulbs for gooseneck mag base lathe lighting

#1

LED bulbs for gooseneck mag base lathe lighting

Craig Daymon

>I picked up a Delta gooseneck magnetic base light to use with my lathe today. Since I'm thinking of using it to focus either inside or very close to the outside to gauge wall thickness, I'm considering an LED light bulb since they run very cool (also use virtually no electricity, but the lathe makes up for that savings).

Has anyone used these? Is there a downside? (Aside from the price which is more than the lamp it would go in.)

Here's a couple links to what I'm considering:

http://store.advancedmart.com/11acsc28whle.html

http://www.thinkgeek.com/gadgets/lights/7aa8/

http://www.ccrane.com/lights/led-household-light-bulbs/index.aspx

-Craig

Re: LED bulbs for gooseneck mag base lathe lighting

#2

Re: LED bulbs for gooseneck mag base lathe lightin

Rick Allen

>Hi Craig

In order to see scratches and the like you need a point source light. These multi-LED lights are more difused, especialy up close as would be the case with the gooseneck fixture. The color is blue white. Men tend to be unable to focus clearly in blue light. This is new technology and while the LEDs may have a working life of 100,000 hours the same may not be true of the conversion circuitry to go from 120 VAC to the 3 VDC the LEDs need.

These are low output devices. A typical 100 watt light bulb will put out 1700 lumes. The highest output of the lights you are considering is 120 lumes. That would be close to a 15 Watt bulb. If you want a good idea of the brightness you can expect from the $20 LED spotlight then put a 15 watt halogen where you want this gooseneck and decide if that is enough light.

Pros:

The geek meeter reads quite high

Uses very little power

Cool to the touch

Potential to last forever

Cons:

The Geek meeter reads quite high

Low output of light

Blue light

Can't produce sharp shadows so not good for inspection

New technology that will very likely be improved a LOT so that the long life is never realized.

If you are looking for a good inspection lamp then the Moffit lights with a 100 watt light bulb are hard to beat.

Good Luck

Richard

Re: LED bulbs for gooseneck mag base lathe lighting

#3

Inspection lamps

Fred in NC

>Never heard of Moffit lamps, and a search did not turn out anything. Would you mind giving me a hint where I can get them? I am about ready to get a better inspection light, actually, 3 of them. Thank you very much !

Re: LED bulbs for gooseneck mag base lathe lighting

#4

Re: Inspection lamps

Halsey

>You might try Turningwood.com Halsey

Re: LED bulbs for gooseneck mag base lathe lighting

#5

http://www.turningwood.com/light_stand.htm

Clem Wixted

>

Re: LED bulbs for gooseneck mag base lathe lighting

#6

Thank you, guys !! .

Fred in NC

>Thanks guys !!! That is a very nice setup.

One thing I found is that the clear light bulbs are better for inspection, since the light is not diffused by the frosting. A point light source is best.