Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Serious Lathe tools

Posts

Serious Lathe tools

#1

Serious Lathe tools

Shawn - in ID

>I seem to recall a post a couple of years ago on this but...

I have a 1/2 bowl gouge from Serious Lathe and like it a lot. They have great prices compared with others. Now I'm getting a 5/8 and wondering if anyone can directly compare the Serious Lathe bowl gouges with others?

Re: Serious Lathe tools

#2

Re: Serious Lathe tools

Rick Allen

>Please note that Serious Lathe tools are high carbon steel not HSS so blueing the tool while sharpening is a bad thing.

The tools are longer than other brands so you get a good long tool that has a good heavy feel in your hand.

The edge holding seams fine to me. You should always have a sharp tool for finish cuts so the edge holding is of little consquence to me.

I find the flute shape to be of my likeing and is simular the flute found on Crown bowl gouges which is slightly less "U" shaped than Sorby but no where near as "V" shaped as found on Glaser tools.

The flute is half the lenght of the tool and because the tool is so long the flute is longer than other brands. This is long lasting tool with the weight to dampen vibrations.

Is that what you had in mind?

Re: Serious Lathe tools

#3

Re: Serious Lathe tools

Shawn - in ID

>Yep, thanks Rick. You say you think edge holding is fine. Buy,how do you find the edge holding compared with others? With so much more tool for the dollar, I'm trying to determine 'bang for buck' (or maybe 'sharp cuts for the dollar'). Thanks.

Re: Serious Lathe tools

#4

Re: Serious Lathe tools

Rick Allen

>Cutting feet for the buck? I would guess that Benjamins Best from Penn State are the best deal.

For me edge holding isn't very important as I sharpen my tools all the time. I have some Glaser tools which I am very fond of. But I am fond of those expensive tools because I like the way the tool feels in my hand. I also like the feeling I get that the tool I am using is without compromise.

If you are happy with the Serious Lathe tool you have then why wouldn't you be happy with a larger tool from Serious Lathe?

You think that a different manufactures tool is going to provide you with more sharp cuts per dollar?

I am less judicious with my tools. I sharpen my tools prior to use and again before the final cuts. It doen't matter if the tool is Serious Lathe or Glaser or Sorby. I am sure that some folks make sure they get all the cutting that can from a tool. I am not one of those folks.