Re: Buff/Finish questions
RussFairfield
>There is nothing different about mixing waxes and finishes when they are applied with a buffing wheel. Wax is wax, and it will have the same effect on the finish, regardless how it is applied.
The binder in the Tripoli is Tallow, animal fat. The binder in the White Diamond varies with who made it. Some use paraffin, and some is a combination of paraffin and carnauda. I have no idea what is in the Bealle version. It seems to be on the harder side, so I would suspect that it has a lot of Carnauba in it.
There is no problem with putting lacquer on the wood after buffing it with the White Diamond. Just make sure you have removed all of the white residue with a paper towel, and use a scrub brush or a tooth brush to clean out any that may be in the grain or voids.
If you are going to use a lacquer, I recommend that the first coat of lacquer be applied with a brush, and a sloppy heavy coat; and that the wood be wiped as clean as possible as quickly as possible before the lacquer starts to dry. Use some thinner if necessary. Buff the wood with steel wool if there are any streaks in the lacquer. Doing this cleans the surface of all residual wax and forms a primer coat so the following can be sprayed or brushed without any problems from the wax.
The worst that can happen from any residual wax that is on the wood is that it will be absorbed into the lacquer promer coat and act as a plasticizer. That will make the lacquer film softer than it would have been without it. This could be a good thing in the long term because it will become less brittle with age. However in the short term, it will make it more easilly damaged by buffing should you choose to do that.
If you are going to buff the lacquer finish after it has dried, it be better to a[pply it before buffing, not after.
For oil based finishes, everything I said about lacquer is the same. The difference is that the oil finish will remain more flexible in the long term, and less likely to crack with wood movement.
My opinion on "popping" the grain us that it has more to do with sanding than what finish we use. Sanding to the finer grits seals the wood, and the finer you sand, the more the wood is sealed. There will always be a difference in the absorbtion of the finish at any degree of sanding, and the finer the sanding grit, the more the grain difference is accented. I typically sand to 600-grit, and sometimes go to 1200, followed with burnishing with grocery bag paper. Although I have always been told different;y, I have never had a finish fail because the wood was polished to too fine a surface.
Once sanded, you can "pop" the grain with either lacquer or an oil based finish. The oil may be easier because of its natural tendency to make end grain much darker than the flat grain, meaning you can get a grain accent with less sanding, but the sacrifice is that the the accented grain may have a blotchy appearance. That blotchy appearance will disappear as the wood is sanded to finer grits. Taken to a higher polish before putting on a finish, the higher gloss of the lacquer will always be a brighter accent than an oil finish.
I think that most of us prefer the oil finishes because they are easier to apply, shop dust is less of a problem, and there are fewer long term problems ith yellowing and brittleness, unless we use a better grade of lacquer than Deft..