Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Bent quill on DVR??

Posts

Bent quill on DVR??

#1

Bent quill on DVR??

Bill MacLachlan

>I think I have a bent quill on my DVR and looking for other suggestions in case it is not. I have about 1"-1.5" free travel to fully extend the quill, but it is extremely tight when trying to screw the quill in. It almost feels like I am cutting new thread!!

I have taken it apart and cleaned out the dirt and re-greased but did not much help. Any suggestions before I order a new quill and handle?

I have posted on the MSN Nova group, but this is a more active group.

Thanks again for all your help, Bill

Re: Bent quill on DVR??

#2

Re: Bent quill on DVR??

Barry Irby

>I just (about a month ago) sent a query to Teknatool about the threads on my quill. They were poorly made, looking as if the toll that cut them had chattered. I turn mostly bowls and had not use the tailstock as much as a spindle turner might, but it got to the point that it felt "gritty" and was difficult to tighten and especially loosen. The Company sent me to Tim Giest, their service guy in this end of the country. I talked to him and he said he had not noticed the problem. He looked at some of his and agreed it might be a problem. He send me a new quill and handwheel (free) and I sent the old ones back. Cost me about $7 shipping. Teknatool has been very stand up about their products. If you need Tim's number and address let me know.

Re: Bent quill on DVR??

#3

PS. My DVR is over 3 years old.

Barry Irby

>

Re: Bent quill on DVR??

#4

Re: Bent quill on DVR??

Bill MacLachlan

>Thanks Barry. I sent a note to KMS Tools and they supplied me with Tim's phone number. Sounds like it might be the same thing. I have a buddy who is a machinist and I am going have him chuck it up in his lathe and see if still straight. I think I may have bent the quill taking the tail stock off and laying on the bench, while trying to get more elbow room.

Bill