Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Grinder tune ups

Posts

Grinder tune ups

#1

Grinder tune ups

TD

>A thread is running below about some grinder balance problems. Several have mentioned truing the sides of the wheels. Note that if you true the sides of a wheel that is wobbling you may make matters worse. It becomes necessary to take exactly the same amount of weight off each side of the wheel, 180 degrees apart. If the wheel is not standing 90 degrees to the shaft and you take off mass on the front left side then you have to take off an equal amount on the rear right side. It is far better to get the wheel running true. Look at the plates that support the wheel. If they are thin (like washers) they need thrown away and replaced by either the One-way plates or a custom made set by a local machine shop; or spend a few more bucks and get a good grinder to start with and all this becomes unnecessary. Some of the cheaper grinders work with the thin plates until you hang a tool between the wheel and the toolrest. When this happens it bends the thin plates and allows the wheel to wobble. On better grinders you will not bend the plates.

TD

Re: Grinder tune ups

#2

Re: Grinder wheels

Jill

>Any suggestion as to where I might get a White Aluminum Oxide, 8x1 7/8 hole, 100-120 grit grinding wheel. Do all grinding wheels come with various size bushings for the hole?

Re: Grinder tune ups

#3

Re: Grinder wheels

TD

>yes, bush the hole to the desired diameter. You can buy these or you can turn them yourself from hardwood or plastic.

Re: Grinder tune ups

#4

Re: Grinder wheels

-e-

>jill- packard sells the white ao wheels -- they come with several stacked, removeable plastic inserts for the hole. i'm certain if you call packard they could get you specific specs.

also, check out the wheels from oneway -- i much prefer these to the white wheels and have changed over.

Re: Grinder tune ups

#5

Re: Grinder wheels

Jill

>Thanks guys. I will check Packard and Oneway. I haven't bought a wheel for my grinder in years and was not sure about the bushings. Your experience is so helpful. Thanks,Jill

Re: Grinder tune ups

#6

Re: Grinder wheels

Ed Moore

>Jill,

You would do well to consider the Oneway wheels. Also good, but more expensive, are the Norton SG wheels.

Ed

SW VA

Re: Grinder tune ups

#7

Re: Grinder wheels

Vicmarc.fan

>We all make the mistake of not wanting to pay for what we get. I got two white wheels from Packard because they were cheaper than Oneway. Problem is they are so soft they are worn out already. Am I going to get Oneway? No, I will save for the Norton wheels because guys in our club say they hardly ever true their wheels because they wear so little.

Ron