Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

hollowform question

Posts

hollowform question

#1

hollowform question

ken chase

>Just turned a hollowform out of very green peach. Should I coat it

and bag it to dry or is it all right to sand and finish it the way it is. It is oriented cross grain. This is the first I've done this way and I don't think I'll ever go back to turning one end grain with hard dry wood as I have in the past.

Thanks

Re: hollowform question

#2

Re: hollowform question

Carole in VA

>Ken, you're in the desert so I wouldn't be a bit surprised if it hasn't already cracked and warped by the time you get this! My experience is somewhat limited, but I have found any type of fruit wood to be very unstable. I rough it out, boil it for an hour or so, let it sit in the water until it is room temperature, then soak it in denatured alcohol overnight. Let the alcohol evaporate from the surface, bag it and hope for the best. I hope you left the roughout thick enough to true it up after drying. The other option, which I have not tried, is finish turn it very thin (consistent throughout) and let nature have it's way with the warping. I am sure other more experienced folks may have some better ideas.

Re: hollowform question

#3

Re: hollowform question

Barbara Gill, Remlik VA

>I have had pretty good results with soaking the finished hollowforms in denatured alcohol.

Re: hollowform question

#4

Re: hollowform question

georgetroy

>I don't have the patience to go through a system of air drying, bagging, nuke, or alcohol. Turn it thin. I suggest you finish it all the way and see what happens. Sooner is much better than latter. When I turn solid wet wood, end grain or flat grain. I seal with Deft lacquer, sand, and apply several coats of Oil. No Watco ever for me. I'm showing maybe 20 little pear vases turned end grain. These are ready to carve, pierce, paint, and leave natural. All turned wet. Some will warp, other not. You can see one flat grain small bowl that has a nice warp. If you leave piths near the top you will get more warping. GT


img

Re: hollowform question

#5

Re: hollowform question

Raymond Overman in SC

>John Jordan did a demo for our club and said that you should finish turn a hollow form as uniformly thin as possible and then restrict the airflow around the piece. It will warp but being a hollow form, it doesn't matter. A lot of the warping, cracking, and uneveness of a piece comes from selecting the right place in the wood. The mouth of the hollow form should be in line with the pith and equal amounts of wood should be on each side to accomodate a uniform warp.

Personally, I still finish mine to 1/10 thickness of the diameter, place it in alchohol overnight, then restrict the airflow around the piece for approximately 3 weeks. I don't know if the second part of the equation is all that's required or not because mumbo jumbo or not, I get the result I'm looking for and have had good result with peach.

Good luck.

Re: hollowform question

#6

Re:Thanks for the great hollowform help

ken chase

>