We value your privacy.
We use cookies to enhance your browsing experience, analyse site traffic, and personalise content.
By clicking “Accept all”, you consent to our use of cookies. You can also choose
“Essential only” or learn more.
>I got this chunk a while ago, but last week, I finally felt brave enough to turn it. This was definetly an experience, it sounded like a helicopter while it was on the lathe. It got a little better when I had it turned a bit, but I was very happy that my lathe is bolted to the floor.
I could only speed it up to about 600rpm before it just sounded too scary.
the rim is about 1/4" thick now that it is carved. I used a proxxon minigrinder and the 2" Kutzall wheels to carve the design.
after that a Proxxon electric carver and lots of sandpaper.
this was fun but so far the scariest bowl I have turned.
>And quite an undertaking, too! Impressive, I like the carving between the two bowls, makes it appear to have been folded. Great work, very innovative.
That wood looks incredible, the turning is most impressive, I can not imagine what it must have been like to create that wonderful work...a wild piece!!
>You have a winner here Sascha, great imagination, and display of skills! Someday when I get comfortable finish turning I will have to try carving. You sure made this turning extra special.
How thick is it, doesn't look like there is much wood left in places?
>Amazing. What braveness, fearless spirit combined with boundless creativity! Reminds me a bit of the thrill of starting the airplane engine by pulling the prop through.
This got me to wonder about other less dangerous ways mere mortals like the rest of us could turn such things and live to tell about them. The first that comes to mind is a robotic lathe where the gouge spins instead of the wood, controlled perhaps by linkages or remotely with servos. Spinning a camera with the tool could let you see exactly what you are doing. Sounds expensive and a nightmare to maintain, but could "turn" any size, even in place on the tree.
More practical: mount the piece in some large circular frame with the piece embedded in something, perhaps lightweight expandable foam or some other casting. Or perhaps the work could be held in a positionable clamp or other mounting device.
The frame could have a wide, smooth rim to eliminate the life-altering propeller.
>Hi Sascha, I put something similar to this up on WOW last week and was told I was crazy,among other things. Very happy to see that someone else enjoys doing "crazy" things. Nice job,be careful and keep it up....