Worth learning and not hard at all... *LINK*
David Barnett - Venice, Florida
>You probably have most of the tools you need (ballpein hammer, files, jeweler's saw and/or hacksaw, propane torch) and nothing special's required (you don't need expensive 'stakes') until you start doing a lot of it. Practice on copper, buy some sterling sheet, make a spoon, a fork, buy the knife blanks from TexasKnife as Steve suggests. Tim McCreight's "Complete Metalsmith, Professional Edition" is a must, and also helpful is a little 14-page Flatware design manual*. Check out a couple silversmithing texts from the library, keep it simple and just do it.
*http://www.gesswein.com/catalog/catalog.cfm?cat=12&sub=3&subsub=26&catalog=1&CFID=393467&CFTOKEN=47821190
Complete Metalsmith