Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

[Tool Question]Sorby Revolving Steb Centers

Posts

[Tool Question]Sorby Revolving Steb Centers

#1

[Tool Question]Sorby Revolving Steb Centers

Michael Schneider

>Hello All,

I was poking around some catalogs to make a list for santa and

came across Sorby Revolving Steb Centers.

I really like their drivers, but I am at a loss the value gained by using a revolving steb center on the tail stock.

Any help would be welcomed :-)

Thanks

Mike

Re: [Tool Question]Sorby Revolving Steb Centers

#2

Re: [Tool Question]Sorby Revolving Steb Centers

John Lucas

>Mike I would guess that it probably holds better than a cone center and probably doesn't dig in like a pointed center.

Re: [Tool Question]Sorby Revolving Steb Centers

#3

Re: [Tool Question]Sorby Revolving Steb Centers

Ed Moore

>Mike,

I like having the drive and the tailcenter both of the Stebcenter format. For one thing, if I decide to switch ends for some reason, the centers engage precisely with no difficulty.

As John said, you get an accurate placement and the springloaded point does not drive into the wood and thereby risk splitting it.

The Stebcenters are my centers of choice now that I have used them a little.

Ed

Re: [Tool Question]Sorby Revolving Steb Centers

#4

Re: [Tool Question]Sorby Revolving Steb Centers

Dick Anderson

>I like the Steb Center very much. By using a minimal set of the spurs into the wood you can reduce the nasty effects of a catch since the spurs will break free of the wood and the spring loaded pin will still be holding the wood. Try experimenting by using a small diameter (rounded) blank at a slow speed with the spurs barely engaged (only enough to allow the wood to revolve) then stop the woods rotation with your hand. Just be careful as always. I have also had a spindle break in the middle (was very soft buckeye burl) and rather than the two pieces jamming or flying off the lathe the spurs broke free and the piece stayed in place until I could shut off the lathe.

Re: [Tool Question]Sorby Revolving Steb Centers

#5

Re: [Tool Question]Sorby Revolving Steb Centers

Michael Schneider

>Thanks Guys,

I'll give one a try,

Mike