Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Swan Neck Hollowing tool question

Posts

Swan Neck Hollowing tool question

#1

Swan Neck Hollowing tool question

Vicmarc.fan

>Why do you put only the straight part of the tool on the rest?

Ron

Re: Swan Neck Hollowing tool question

#2

Re: Swan Neck Hollowing tool question

Mac

>Because the straight part is the part that lines up with the cutter,if you put the bent part on the rest,the cutter is way beyond the center line and it will drop down and catch.Just try it very carefully and you will see that the cutter should always line up with the center of the bar.The whole bar will twist if the cutter is off the center line,very dangerous.........be careful when you try this......take care.....