Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

Industrial Abrasives

Posts

Industrial Abrasives

#1

Industrial Abrasives

Bill Grumbine (Kutztown PA)

>Greetings all

Over the weekend, I discovered, much to my dismay, that I was perilously low in some sandpaper grits. There are several sources close to me with paper available, but not in the form to which I am used. Recalling some glowing comments about Industrial Abrasives, I did some searching on the web and found their site. Just out of curiosity, I looked for their physical address, and to my surprise, I discovered that they are about 20 miles away from me! So guess where I am going today?

Thanks to Mark and Russ and Dominic for talking them up. It is always nice to have a good supplier close by.

Bill

Re: Industrial Abrasives

#2

Re: Industrial Abrasives

Rick in Colgate, Wi

>I have been very satisfied with them as a mail order customer.

Re: Industrial Abrasives

#3

Re: Industrial Abrasives

Barry Irby

>Bill, Our turning club orders in bulk from them and we are happy with it in general. Check out their sanding disks too. I think they are very reasonable on them also. I am thinking of getting about six, one for each grit and use a quick change chuck rather than changing the paper each time. It would let the disk cool and spread the wear on those little hooks.

I hope you don't take offense at this, but here goes. I Posted a message to someone that they should buy your turning video. I'm happy with mine. The spell checker hit "Grumbine's Video" and suggested "Grubbiness" I had to laugh. Sometimes when I come out of the shop, that's exactly how I feel.