Re: Barbara Gill: A couple of Velvit oil Q's
Barbara Gill, Remlik VA
>How long do you normally wait between coats?
I usually apply the first coat until it no longer soaks into the wood and then wipe off after it just starts getting thick. I wait at least 8 hours before applying a second coat. It depends upon the temp. and how much oil the wood soaked up.
For instance, I just finished turning a maple plate which must have been a little soft as the wood soaked up about 1/2 pt of oil. I will let that item dry much longer than if just a little oil had been used.
Have you ever put a topcoat of Poly over the Velvit Oil?
No, I don't like to use poly. If you use several coats of oil, let cure and buff you will get a wonderful glow to the wood.
How long would you let it cure before using the Poly?
You can use poly over the oil after it is completely cured. Here again cure time will depend upon temp, etc. I always believe in erring on the side of caution. If I was going to apply poly after the oil I would bring the item home (my shop has no heat) for at least several days but more likely a week before applying poly.