Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Sanding Spalted Maple

Posts

Sanding Spalted Maple

#1

Sanding Spalted Maple

Dave Winters, Steamboat Springs, CO

>I haven't ever turned much spalted wood before. I can get a pretty good surface off the tool by careful shear scraping, but when i go to sand, the softer parts sand away much quicker than the harder. How do you deal with this? CA the soft stuff? Hand sand? Power sand? Thanks in advance.

Re: Sanding Spalted Maple

#2

Re: Sanding Spalted Maple

George Van in WI

>Hi Dave,

My best results have been power sanding with the lathe off. I tend to follow the grain being careful in the softer areas. I finish with the finer grits hand sanding. When I tried to sand with the lathe spinning I had a bumpy ride. I have not used the CA as I was worried about staining the wood. I have used a coat of Deft before starting but I prefer not to as it plugs the paper quicker.

Re: Sanding Spalted Maple

#3

Re: Sanding Spalted Maple

George Van in WI

>I also might mention that you try a PowerLoc disk if you have one available. I have had good results after they were recommended to me. They do not flex into the softer areas seeming to hit the hard surface and skip the soft.

Re: Sanding Spalted Maple

#4

Re: Sanding Spalted Maple

Tom Stover

>You might try some rotted wood hardner by Bondo or Minwax. Available at your local borg.