Re: 24"
Mark Mandell - Gone Round In Jersey
>JK,
Once you get out of the "Limb,Trim & Thin" group running up to 20" bars, everyone I've spoken to says go for the pro side of the mid range saws for the next step because of their advantages in power-to-weight, RPM, and engine component quality and durability. The two saws that seem to fit your question (not to slight other brands here) are the Husky 357XP and the Stihl MS 361 (O36-Pro). Both deliver a bit over 4hp yet only weigh in at a tad over 12 pounds. The Husky has the edge in RPM at 14,000+. Both have compression release to ease starting (the Stihl may offer their new spring starter) and both are rated to pull a 28" bar, so 24" will not strain either the motors or the clutch systems. A very useful accessory for a turner is a double dawg set up (bucking teeth on both sides of the bar), but I don't know of it is available as an option on either saw. While I haven't priced Stihls lately, the Husky with a 24" bar will run you somewhere in the mid-500's plus tax or shipping. You won't, however, find either saw at the Borg, regardless of color.
Oh, in case you're wondering, I use a 15 year old Stihl 023 pulling a 16" bar and a Husky 372XP pulling 28".
Hope this helps. |;-}
M