Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

I hate it when this happens!

Posts

I hate it when this happens!

#1

I hate it when this happens!

Carole in VA

>I was using my drill press yesterday and heard something metallic hit the concrete floor. Sounded small and I didn't see anything so I just coninued what I was doing and forgot about it. Figured it must be a nail or screw that rolled off the bench. This morning I find a small L shaped piece of round 1/8" steel on the floor by the drill press - obviously a part of some sort that I have never seen before. It's driving me nuts trying to figure out what it fell out of! LOL

Re: I hate it when this happens!

#2

Re: I hate it when this happens!

Scott Ruesswick in NH

>I will guess that you have a Delta drill press. If I remember correctly it has an indexing pin that meets your description. I will have to check tomorrow when I am in the shop, er Studio. Scott

Re: I hate it when this happens!

#3

Re: I hate it when this happens!

Carole in VA

>Yep. It's a Delta 16 1/2" press. Don't know anything about an indexing pin though. Maybe I will go to their site and get a parts diagram and see if I can find it. It's not very big - about 3/4" each leg of the "L"

Re: I hate it when this happens!

#4

Re: I hate it when this happens!

John Lucas

>I would have to look at my parts diagram but I think he's right. I had my locking pin quit working. It would only rotate about an inch. I took all that section apart and there was a pin about the size you are talking about that had come loose and was hitting the rotating dial so you couldn't set the stop where you wanted. John

Re: I hate it when this happens!

#5

Dick Hines

Re: I hate it when this happens!

Dick Hines

>Carol, if it just fell off you did not need it any.LOL

Re: I hate it when this happens!

#6

that little guy at it still???

Kevin Turner

>I think someone is attempting to drive you to the loonie bin.....Watch tomorrow it will be gone...LOL

Re: I hate it when this happens!

#7

Re: that little guy at it still???

Carole in VA

>Better not be! I put it right on the drill press table. If it is not there in the morning, I'm hiring an exorcist!

Re: I hate it when this happens!

#8

Re: that little guy at it still???

Jennifer@Indy.USA

>Okay, Who's got the spare key to Carole's shop? Sneaking in there hiding stuff....you should be ashamed!

Carole, If the piece is still there in the morning, I hope you find out where it goes. It is rather nerve wracking to not know where a loose piece off of your machinery goes!

Good Luck.

Jen

Re: I hate it when this happens!

#9

Re: I hate it when this happens!

Scott Ruesswick in NH

>Well, my drillpress index pin is larger than what you found on the floor. Good luck figuring it out. Scott