Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Help for Jet Motor

Posts

Help for Jet Motor

#1

Help for Jet Motor

Don from Denver

>Am relatively new to turning, (and feeling more so today). I have a Jet 12 inch lathe and had trouble with it starting today. At first if I manually spun the piece it would continue to run. Eventually, sparks flew out of the capacitor and liquid wax seeped from under the cover and I shut it off. I assume I need a new "motor start capacitor" which is what the old one says on its side. I am having trouble finding one with exactly the same specs. Is this a common problem? Do I need to look for other problems that caused the capacitor to burn up? Help!!

Re: Help for Jet Motor

#2

Re: Help for Jet Motor

Bill Howatt

>Motor starting capacitors do go bad. As always there may be another problem but from your description that is unlikely. If you had a stuck start switch the motor probably wouldn't have reached full speed I think and you would have burned the start winding.

Have you taken the capacitor to a motor repair shop? These guys usually have the experience to give you one that will do the job event if the value isn't exact. Of course, you could just take the whole motor in and have it looked at in case there is another problem.

Bill

Re: Help for Jet Motor

#3

Re: Help for Jet Motor

Don from Denver

>thanks for the response Bill. I am anxiously waiting for Monday for the motor repair shops to open. I did try a capacitor from an appliance repair shop last night, somewhat more mfd than the original, but only succeeded in blowing a circuit breaker.

Re: Help for Jet Motor

#4

Re: Help for Jet Motor

Bill Turpin in WNC mountains

>If the start switch is stuck closed, either with sawdust in motor or welded contacts, or burnt contacts the start winding will stay energised TOO long or not at all. This will boil the salt solution in the capacitor, pressurizing it, which will blow the wax plug between the cap's terminals. This will then probably take the start winding out of the circuit. The motor will then fail to start and draw excess amps tripping the circuit breaker. The bad cap is a result of the real problem. You need to take the motor in. Caps can be replaced with a higher mfd within 10%, never lower. The caps voltage is an insulation rating. Go equal or higher. Quite often, 120 volt motors have 330 volt caps. This is necessary to satisfy inrush currents and induced voltages in various types of motor windings.

Bill in WNC mountains