Turning Help!
Patrick Capobianco
>I'm in the process of turning a pepper mill, I always have problems with the tools catching on the wood, especially when forming the top. I've tried spindle gouges, skews, and even scrapers, what am I doing wrong?
Knowledge You Can Build On — Est. 1998
Turning Help!
Patrick Capobianco
>I'm in the process of turning a pepper mill, I always have problems with the tools catching on the wood, especially when forming the top. I've tried spindle gouges, skews, and even scrapers, what am I doing wrong?
Re: Turning Help!
Jim Pugh, Ohio
>The spindle gouge should be the one to use. Pay attention to where the bevel of the tool is touching. It should touch before the cutting edge then raise/swing the handle until you get a cut going. Some of us get the cutting edge into the work before the bevel touches and unpleasant things happen - like spirals and such.
Re: Turning Help!
The Wood Spinner / Bill Hale
>Don't know how fast you turn but on small work I run the speed way up and take finer cuts. Slow and easy with a SHARP tool.
Good turning and be safe
Bill in Casa Grande, AZ.