Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

Dave Smith, here is what became of that madrone.

Posts

Dave Smith, here is what became of that madrone.

#1

Dave Smith, here is what became of that madrone.

Al Crandall- NE of Indy

>If you go to the club's web site, www.cicaaw.org, open the link in the middle of the page for October meeting pictures. On page one and two are shots of the instant gallery, taken by our hard working club secretary James Purciful, where you will find "your" log after I modified it. Thanks.

Re: Dave Smith, here is what became of that madrone.

#2

When did Longview change to Clearview?

Dave Smith, Longview, WA

>Hi Al,

The urn is a beauty. What finish did you put on it? How did you like turning the wood? Did you save any small pieces for pens and such?

Dave Smith

I think I am in Longview, WA.

Re: Dave Smith, here is what became of that madrone.

#3

It's a personal agenda to change your city's name.

Al Crandall- NE of Indy

>Don't you think Clearview sounds much more upscale than Longview? Come on, help me out here. (This won't make sense later because I can go back and edit that booboo.)

I boiled the roughout for 3 plus hours and alcohol soaked it for eight days. It took about a month for it to dry while wrapped in brown painter's masking paper. The urn has about 4 or 5 coats of Watco natural Danish oil and then buffed with Rockler's version of the Beall system. I didn't use the wax yet because I think I'm going to have to go back and resand the finish. It seemed to "tear" or ripple up when I buffed it in a couple of places. I think it might not have been fully cured. The finish seemed to take forever to dry because the piece soaked it up like a sponge. The inside was wetted to about 50% while I was still brushing the first coat on the outside so I poured a cup into it and sloshed it around. Subsequent coats were very slow to dry. The wood turned like a dream with no tearout and emitted a faint pleasant sweet aroma. It was cracking radially like you wouldn't believe when I started. I lost about 3 inches off each end and about 3 to 4 inches off the diameter before I found reasonably sound wood. There was barely enough to make the threaded foot from, let alone any pen blanks.

Re: Dave Smith, here is what became of that madrone.

#4

Dave - move to Clearview

Ray Johnson

>Its just around the corner from our other place. You would like it, there is only 1 light and 1 intersection. Good restaurant. Expensive service stations, a few other stores.