Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

?? about Beale System

Posts

?? about Beale System

#1

?? about Beale System

KurtK in INdy

>I have a Beale buffing system and have had it for a couple years. I haven't used it for some time and just got it back out a couple weeks ago. I have noticed that all of the charging agents (Tripoli, Wh Diamond and the wax) are really hard, almost petrified. Is this right?? I seem to recall that when I first got the system that all of these were relatively soft, at least softer than they are now. I can't really tell if I'm getting much on the wheels.

I guess the main question is...is there a shelf life for these compounds???

Thanks for all answers.

Kurt

Re: ?? about Beale System

#2

Hi Kurt

Jim Shaver - Oakville, Ontario

>Hi Kurt,

I do not think so, I have been using the original ones for 6-7 years, they seem fine, I charge the wheels when they are running, they work very well.

Take care,

Jim

Re: ?? about Beale System

#3

Re: ?? about Beale System

Earl Eyre

>I just bought the system last week. All the charging agents are rock hard. In fact, I promptly dropped the wax and it shattered! So I think you are in good shape.

Earl

Re: ?? about Beale System

#4

Re: ?? about Beale System

Jill

>Same here I have had mine for 7 yrs and still use the compounds with GREAT results.

Re: ?? about Beale System

#5

Re: ?? about Beale System

Ed Moore

>Kurt,

I think the compounds are fine. But, you should work on the wheels a little before you use them on a turned piece. Take a tool with a rectangular cross-section and use it like a scraper to remove some of the old compound on the wheel. I use the back of a Chris Stott parting tool, for example, or the back edge of a piece of a large hacksaw blade, and hold it horizontal and aggressively attack the wheels so as to soften their fringe. This should remove chunks that have hardened and would damage the surface of a turning.

Ed

Re: ?? about Beale System

#6

LOL! I did the same thing!

Carole in VA

>Dropped the carnuba onto the concrete floor when I was removing it from the package. Lots of tiny little shards. I used the 60 grit sandpaper and then the toothed side of a piece of old bandsaw blade to clean and "fluff" my buffs.

Re: ?? about Beale System

#7

Re: ?? about Beale System

Brian Hahn in SW Wisconsin

>The shelf life of the buffing bars very, very long. Abrasives are quite stable and so are the wax binders. I have a jeweler's rouge bar that I can remember my Dad using back in 1959 and it still works fine.

Re: ?? about Beale System

#8

Thanks everyone!!

KurtK in Indy

>I think I'll take an old hacksaw blade to those wheels and see what that does. Again, thanks for the replies.

Kurt

Re: ?? about Beale System

#9

Re: Thanks everyone!!

JamieDonaldson

>Break off a section of the hacksaw blade and hold it with Visegrips, definitely not in your bare hand!