Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

What would you do with this?

Posts

What would you do with this?

#1

What would you do with this?

Carole in VA

>The picture doesn't do the "muscular" form justice. It is maple and I have just been staring at it. The more I look, the more I think Mother Nature made a wonderful sculpture and that I maybe shouldn't do anything to it except sand and finish it. Of course that may be because I am basically chicken to do anything with it! The back is flat and the top had wonderful ripples and curves. The crack in the front does not go all the way through. I get the feeling that if anything, it should only have a bowl in the middle, but it is too large to put on my lathe as is.


img

Re: What would you do with this?

#2

JL

Re: What would you do with this? - Size?

JL

>

Re: What would you do with this?

#3

Re: What would you do with this?

Kevin Turner

>Carole, What about cutting the bottom section. Where the bottom left side curves...leaving out the crack running down the center. Arch the cut, mimicing that corner.

Re: What would you do with this?

#4

18 1/2 diag x 4

Carole in VA

>My lathe will swing that outboard, but I don't feel experienced enough to turn something like that without a tailstock. :( I also don't have enough weight in my stand.