Got my lathe..... Now what?
kds99
>so i ended up picking up a lathe at harbor freight, and have no idea what i need to get for it as far as tools. I plan to start turning spindles and will move to bowls in the next few months.
Help
Knowledge You Can Build On — Est. 1998
Got my lathe..... Now what?
kds99
>so i ended up picking up a lathe at harbor freight, and have no idea what i need to get for it as far as tools. I plan to start turning spindles and will move to bowls in the next few months.
Help
Re: Got my lathe..... Now what?
JL
>Pick up a copy of Keith Rowley's book "Woodturning, A Foundation Course". If you get the video, that might be good also. You got the lathe but no tools? A good set of basic tools would be in order. Roughing gouge, parting tool, spindle gouge, skew (I'm partial to an oval myself, though a rolled edge works also). Buy reasonable quality rather than cheap. Buy a set if that works. Get a grinder to keep the tools sharp - 8" or 6" wheels. Buy or make jigs to sharpen the tools. Get some scrap lumber (close grain, preferably not pine). Start practicing.
My $0.02
Re: Got my lathe..... Now what?
tdaniel
>Back to Harbour Freight for their set of tools (8 pc). This set is actually pretty good steel and will get you started and at about $5 per tool you won't go broke while learning how to sharpen. Get the best grinder you can afford but not a variable speed. Some instruction to get started will likely save you a couple of trips to the ER. If you cannot afford instruction then get a starting video. A good quality dust mask and a face bubble and you are ready to start.
TD
Re: Got my lathe..... Now what?
kds99
>Let me add that I have been working wood for about 6 months now and take safty very seriously....
I guess i was wondering more about chucks. After reading turning forms i see people mention all the time about buying different chucks. How does that apply to a new turner?
Re: Got my lathe..... Now what?
tdaniel
>You said you wanted to start with spindles so you don't need a chuck yet. Later, when you start doing bowls you may want to invest in a chuck although it is not necessary. It would be on my list somewhere after a good grinder and sharpening jigs.
Re: Got my lathe..... Now what? *LINK*
Gordon Seto
>There are so many tools and accessories that you want to have, probably make life easier if you have. The difficult part is there are also something looks good in catalogs, but are useless. There are almost endless choices in each category, ranging from $30 a set of eight High Speed Steel gouges from HF to more than 200 dollars for a single Glasser gouge.
The best practical advice is empowering you with knowledge. It would shorten your learning curve and help you spend more wisely.
Check your library for books and DVD in this subject.
Attend an AAW (American Association of Woodturners) local chapter meeting. Most clubs have books and videos let members to borrow. They are the bunch who are eager to help. The membership is arguably the best value.
Take some hands on lessons. A lot of the experienced turners in your local club may be willing to show you how to get started for just a smile and "Thank You". They did to me not very long ago and still offer continue helps and support now.
The AAW link below has 250 local chapters listed:
AAW
Re: Got my lathe..... Now what?
Robert Simmons
>A face shield should be at the top of your list along with a basic tool set. Just remember that safety glasses may save your eyes but they won't protect your teeth.
Robert