Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Folks ... need advice on a sub-$1000 lathe

Posts

Folks ... need advice on a sub-$1000 lathe

#1

Folks ... need advice on a sub-$1000 lathe

John Snyder

>I'm a weekend ww & want to upgrade my aging Jet 1236. I checked out the "new" Jet 1442 & it looks promising ($869 w/leg kit). I've been out of the "new tool" loop for a couple years & was wondering if there's anything new out there that may be a better deal than the beefier Jet 1442 in the same price range ?

Much appreciated ...

John

Re: Folks ... need advice on a sub-$1000 lathe

#2

JL

Re: Folks ... need advice on a sub-$1000 lathe

JL

>The Jet is probably your way to go. I don't think much of the Delta 46-715, which is somewhat comparable. You would be happier with the Jet. Of course, if you can "stretch" your budget... On the other hand, you may want to look at a Grizzly. I don't have any personal experience with one, but their "heavy duty" lathe is in the right price range ($795).

Re: Folks ... need advice on a sub-$1000 lathe

#3

Steven Antonucci

Nova 3000 (non DVR)

steve antonucci

>I have one for about 4 years, and I'd say it's the way to go. Should be about $900, build your own stand out of 2x6's.

Steve

Re: Folks ... need advice on a sub-$1000 lathe

#4

Keith Tompkins

Re: Folks ... need advice on a sub-$1000 lathe

Keith Tompkins

>I think the Jet 1442 is the way to go...it's heavy, with cast iron legs included. Smooth running, variable speed control, well made. If I remember correctly, the headstock slides like the Powermatic. I can't see how you can beat it for the money, unless you find a used PM or General.

Re: Folks ... need advice on a sub-$1000 lathe

#5

Re: Nova 3000 (non DVR)

Larry

>I agree!!! The Nova 3K beats anything else at that price point hands down. Really superb. They might be a little tough to find but well worth it if you can.

Re: Folks ... need advice on a sub-$1000 lathe

#6

Re: Folks ... need advice on a sub-$1000 lathe

Eric

>Word on the street is that Grizzly will have a unit similar to the 20" General for just over $1,000. Supposed to be available in a month or two.

Re: Folks ... need advice on a sub-$1000 lathe

#7

Re: Nova 3000 (non DVR)

Barry Irby

>I'd buy a used DVR. Close to that price from Tim Geist, the Nova Service rep.