Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

weight of blanks on a cheap lathe?

Posts

weight of blanks on a cheap lathe?

#1

weight of blanks on a cheap lathe?

Kevin Turner

>I have a design in mind( as fuzzy as it is). but I'm wondering about the weight my lathe can handle.(powersonic)

Two slabs of Black ash 15 3/8" square by 2" thick. With a segmented ring between the two. I have turned larger bowls, - but nothing that would compare to the weight of the ash. Any thoughts?

Re: weight of blanks on a cheap lathe?

#2

Re: weight of blanks on a cheap lathe?

JamieDonaldson

>I'm not aware of a Powersonic lathe but a Powermatic would be fine if you follow a few basic rules. 1. Always true and balance the blank as much as possible before mounting. 2. Mount securely and use tailstock as both support and safety backup. 3. Start lathe at slow speed and don't stand in free fire zone until you know everything is under control. 4. Wear safety gear like faceshield, flak jacket, steel toe boots,( OK, I was kidding about the flak jacket, but I don't kid about turning safely!)